Bolts, known as industrial meters, are the most used standard parts in industrial production, but at the same time, due to environmental, human factors and other factors will also bring the problem of bite death. Bolt bite will lead to increased difficulty of industrial maintenance, installation work efficiency is greatly reduced, is a problem that should be avoided in industrial production. Therefore, starting from the causes of bolt bite death, this paper analyzes and discusses the treatment measures and prevention measures of bolt bite death. In the process of bolt installation, the staff should avoid bolt bite from the source, so as to effectively improve work efficiency.
In daily life and industrial manufacturing, micro screws and bolts are essential standard parts. From mechanical products to electronic products, from ships, vehicles, hydraulic engineering to chemical experiments, from engineering, construction, Bridges used in the use of large micro screws and bolts to digital products used in the precision micro screws and bolts, it can be seen that the use of micro screws and bolts is extensive and convenient. However, while micro screws and bolts bring convenience to human life, they will also bring some problems, the most typical of which is the bite of micro screws and bolts.
Micro-screw bolt bite is a phenomenon in the assembly process of micro-screw bolts, which is difficult to disassemble and tighten after several assembly. The bite of the micro screws and bolts will directly affect the maintenance and repair of the equipment, which may lead to damage and scrap of the equipment. In power plants, the problem of micro screws and bolts bite to death often occurs, this paper through these examples combined with literature, books and other materials, to analyze and sort out the causes of micro screws and bolts bite to death, and put forward the treatment measures and experience feedback.